Panasonic PT-VW431D - Status Request Commands

S P E C F I L E
PT-VW431D
LCD Projector
As of September 2012
SFL12M015
1 2 / 1 3
Status request commands
Command Description Callback
<Parameter>
QPW
*
Q$S
*
QIN
QAV
QPM
QFZ
Q$L
QSH
Standby power status
Lamp status
Input signal status
Volume adjustment value
Picture mode status
Freeze status
Lamp run time
AV mute function status
Standard
Dynamic
Cinema
Real
Blackboard
Colorboard
Image 1
Image 2
Image 3
Image 4
<power condition>
<lamp condition>
<input signal>
<pl>
STD
DYN
CIN
REA
BBD
CBD
IM1
IM2
IM3
IM4
<off_on>
<acctch>
<off_on>
*
These commands are effective when the standby mode is set to eco. (Other commands are not effective.)
Command example
To set the volume to +30, send the command as shown below.
STX AVL: 30 ETX
Start Command Parameter End
NOTE: When sending commands without parameters, a colon (:) is not necessary.
Parameter format
Parameter format Size (Byte) Definition
<pl>
<off on>
<input signal>
<power condition>
<lamp condition>
<acctch>
3 (1 or 2 bytes also
possible when
under control)
1
3
7
3
1
4
Decimal without signs: 0 to 999 (000, 001, 002...999)
Decimal with signs: -99 to +99 (-99...-01, +00, +01, +02...+99)
Callback from the projector is 3 Byte.
0 = off, 1 = on
DL1 = DIGITAL LINK, HD1 = HDMI, RG1 = computer 1 (RGB),
RG2 = computer 2 (RGB), VID = video, SVD = S-Video,
SCT=Computer 1 (Scart)
When Digital interface box is connected to DIGITAL LINK terminal, and
INPUT is selected to DIGITAL LINK terminal and Digital interface box
at the same time:
DL1:HD1 = HDMI 1
DL1:HD2 = HDMI 2
DL1:PC1 = Computer 1 (RGB)
DL1:PC2 = Computer 2 (RGB)
DL1:VID = Video
DL1:SVD = S-Video
000 = power off (standby mode off), 001 = power on (standby mode on)
0 = standby, 1 = lamp on under control, 2 = lamp on,
3 = lamp off under control
Decimal without signs: 0000–9999 hours