Panasonic PT-VX400 - P-Timer; Closed Caption

Setting
54
- ENGLISH
Settings
P-timer
This function allows you to change the setting of the
P-timer and execute it.
Press ▲▼ to select [P-timer].1 )
Press ► or <SELECT> button to 2 )
access the submenu.
Mode
J
Press ▲▼ button to select one mode 1 )
among the items as below.
Count up
The P-timer display 000:00
appears on the screen and the
count up starts (000:00-180:00).
Count down
The time set in the Timer setting
appears on the screen and the
countdown starts.
Timer
J
Press ▲▼ to select [Timer] and then 1 )
press the <SELECT> button.
Press▲▼ to set the [Timer](1-180 Min).2 )
Timer is available in [Count down] only. Factory
z
default value is 10 Min.
Execute
J
Press ▲▼ to select one among the 1 )
items as below and then press the
<SELECT> button.
Start
It executes the count up or count
down function.*
1
Reset
Reset the P-timer values.*
2
Exit
To exit the P-timer operation.
Press the <SELECT> button at Start and the *1 :
indication changes into Stop. To stop Count up
or Count down, press the <SELECT> button at
Stop on the screen menu, then the indication
changes into Restart. Press the <SELECT>
button at Restart to resume Count up or Count
down.
Press the <SELECT> button at Reset to return to *2 :
the following value:
Count up
"000:00"
Count down
Timer that you set
Attention
To stop the [P-timer] function, press the <P-TIMER>
z
button.
To cancel the [P-timer], press and hold the <P-TIMER>
z
button for a few seconds.
Closed caption
[
Only for NTSC, 480i input
]
Press ▲▼ to select [Closed caption].1 )
Press ► or the <SELECT> button to 2 )
enter the submenu.
Closed caption
J
Press ▲▼ to select [Closed caption] 1 )
and then press the <SELECT> button.
Press ▲▼ to select Off, CC1, CC2, 2 )
CC3 or CC4.
Color
J
Press ▲▼ to select [Color] and then 1 )
press the <SELECT> button.
Press▲▼ to select color or white.2 )
Attention
The closed caption is mainly used in the north America.
z
This function shows the text information contained in the
image signal. Captions may not be displayed on some
devices or software.
You can select [Closed caption] when [NTSC] or [480i]
z
signals are input.
Part of characters may not displayed when high
z
compensation valued are set in [Keystone].
Closed captions are not displayed while the menu screen
z
appears.