Start-up display
When the projector is switched on for the rst time after purchase as well as when [INITIALIZE ALL] is executed in the
[PROJECTOR SETUP] menu, then the initial setting screen is displayed. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
Initial setting (display language)
Select the language to show on the screen.
1) Press asqw to select the display language.
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (projector setup)
Set each item.
1) Press as to select an item.
2) Press qw to switch the setting.
f [PROJECTION METHOD] (
Æ
page 75)
f [SCREEN FORMAT] (Only for PT-VW345NZ
Æ
page 70)
f [SCREEN POSITION] (Only for PT-VW345NZ
Æ
page 70)
f [HIGH ALTITUDE MODE] (
Æ
page 75)
3) Press the <ENTER> button.
f Conrm the setting value and complete the initial setting.
Note
f When the initial setting (projector setup) screen is displayed, you can go back to the initial setting (display language) screen
by pressing the <RETURN> button on the remote control.
f To continue operations after completed the initial settings, refer to “Selecting the input signal” (
Æ
page 44).
PT-VW345NZ PT-VX415NZ
24 -
ENGLISH
Chapter 1 Preparation - Start-up display
To Next Page
Loading...
