[NETWORK/USB] menu
On the menu screen, select [NETWORK/USB] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (Æpage 54) for the operation of the menu screen.
fAfter selecting the item, press asqw to set.
Conrmation of the network information
When connecting the "Wireless Manager ME6.0", the dedicated application of iPad/iPhone/iPod touch/Android,
or the Miracast-certied device to a projector, the information such as Network number of Wireless LAN,
Projector name and Network ID are required. You can conrm the information in the input guide (as the following
picture) or the network status (
Æ
page 91).
[WIRED LAN]
You can make detailed wired LAN settings.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED DETAILED SETUP] screen is displayed.
3) Press as to select an item, and change the setting according to the instructions.
[DHCP]
[ON]:
If a DHCP server exists in the network to which the projector is connected,
the IP address will automatically be acquired.
[OFF]:
If a DHCP server does not exist in the network to which the projector is
connected, additionally set [IP ADDRESS], [SUBNET MASK] and
[DEFAULT GATEWAY].
[IP ADDRESS]
Enter the IP address if DHCP server is not used.
[SUBNET MASK]
Enter the subnet mask if DHCP server is not used.
[DEFAULT GATEWAY]
Enter the gateway address if DHCP server is not used.
[DNS1]
Enter the DNS server address if DHCP server is not used.
[DNS2]
Enter the alternate DNS server address if DHCP server is not used.
[DETAILED] input guide
Network number of Wireless LAN
Projector name
Network ID
ENGLISH
-
85
Chapter 4 Settings - [NETWORK/USB] menu
To Next Page
Loading...
