11 Connecting terminals (
Æ
page 30)
12 Air lter cover
The air lter unit is inside.
13 Air intake port
2 3
1
5
4
r Top
r Bottom
: Projection direction
1 Vertical lens shift dial
Adjusts the projecting position in the vertical direction (vertical
shift).
2 Control panel and Indicators (
Æ
page 29)
3 Lamp cover
The luminous lamp is inside.
4 Air exhaust port
5 Burglar hook port
Attaches a burglar prevention cable, etc.
Attention
f Do not block the ventilation ports (intake and exhaust) of the projector.
r Control panel and Indicators
1 Power button <v/b> (v Standby / b Power on)
Sets the projector to the state where the projector is switched
off (standby mode). Also starts projection when the power is
switched off (standby mode).
2 Power indicator <ON(G)/STANDBY(R)>
Displays the status of the power.
3 Lamp indicator <LAMP>
Displays the status of the luminous lamp.
4 Temperature indicator <TEMP>
Displays the status of the internal temperature.
5 Ambient luminance sensor (
Æ
page 67)
6 <MENU> button
Displays or hides the main menu. (
Æ
page 61)
When the sub menu is displayed, pressing it will return to the
previous screen.
7 <ENTER> button
Determines and executes an item in the menu screen.
8 <INPUT SELECT> button
Switches the input signal to project. (
Æ
page 51)
9 asqw buttons
Used to select the menu screen items, switch the setting or
adjust the level.
Also used to enter a password in the [SECURITY] menu or enter
characters
10
<AUTO SETUP/CANCEL> button
Used to automatically adjust with auto setup function while
projecting the image (
Æ
page 57). It is also used to operate
the Memory Viewer screen and the idle screen of MIRRORING
input and Panasonic APPLICATION input.
ENGLISH
-
29
Chapter 1 Preparation - About your projector
To Next Page
Loading...
