Connecting example: Computers
Control computer
Computer
Computer
Control computer
Computer
USB Memory
Attention
f When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
Note
f For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. If a cable that does not conform to the HDMI
standards is used, images may be interrupted or may not be projected.
f If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume feature to operate
the projector.
f To output the signal input to the <COMPUTER 1 IN> terminal from the <COMPUTER 2 IN/1 OUT> terminal, set the [PROJECTOR SETUP]
menu
→ [COMPUTER2 SELECT] to [COMPUTER1 OUT].
ENGLISH
-
41
Chapter 2 Getting Started - Connecting
To Next Page
Loading...
