Connecting example: AV equipment
Blu-ray disc player with HDMI terminal
Video deck(TBC built-in)
D-sub / component
conversion cable
DVD player Audio equipment
Attention
f Always use one of the following when connecting a VCR.
- A VCR with built-in time base corrector (TBC).
- A time base corrector (TBC) between the projector and the VCR.
f If nonstandard burst signals are connected, the image may be distorted. In such case, connect the time base corrector (TBC) between the
projector and the external devices.
Note
f For an HDMI cable, use an HDMI High Speed cable that conforms to HDMI standards. If a cable that does not conform to HDMI standards
is used, images may be interrupted or may not be displayed.
f The <HDMI 1 IN> terminal /<HDMI 2 IN> terminal can be connected to an external device with the DVI-D terminal by using an HDMI/DVI
conversion cable. However, this may not function properly for some external devices, and image may not be projected.
f This projector does not support the VIERA Link (HDMI).
f To output the signal input to the <COMPUTER 1 IN> terminal from the <COMPUTER 2 IN/1 OUT> terminal, set the [PROJECTOR SETUP]
menu
→ [COMPUTER2 SELECT] to [COMPUTER 1 OUT].
f To output audio, properly set the [PROJECTOR SETUP] menu → [AUDIO SETTING] → [AUDIO IN SELECT].
f When the <VARIABLE AUDIO OUT> terminal is connected with cable, the sound will not be output from the built-in speaker.
40 - ENGLISH
Chapter 2 Getting Started - Connecting
To Next Page
Loading...
