Panasonic RX-C52 - Timer Playback

TIMER PLAYBACK AND RECORDING
eThe
timer
playback
and
recording
functions
are
designed
to
automatically
start
from
the
forward
direction.
As
a
result,
be
sure
that
the
fully
wound
tape
hub
is
on
the
left
side
when
inserting
a
cassette
tape
in
the
unit.
eWhen
performing
timer
recording,
confirm
that
the
record
prevention
tabs
are
intact
on
the
tape
cassette
you
use.
@
Timer
Playback
m@
Timer
Recording
of
Radio
Broadcasts
1)
Connect
as
shown
in
the
figure
below.
1)
Connect
as
shown
in
the
figure
below.
2)
Set
the
power
switch
of
the
timer
to
‘“ON”.
2)
Set
the
power
switch
of
the
timer
to
“ON”.
3)
Follow
the
same
procedure
as
described
in
steps
(1)—(8)
3)
Follow
the
procedure
described
in
steps
(1)-(4)
of
of
“TAPE
PLAYBACK”,
on
page
8.
“Recording
Radio
Broadcasts”,
on
page
9.
4)
Press
the
Stop
Button.
4)
Set
the
timer
to
the
time
that
the
recording
is
to
start.
5)
Set
the
timer
to
the
time
that
the
playback
is
to
start.
5)
Set
the
timer
switch
to
“ON”.
6)
Set
the
timer
switch
to
“ON”.
(to
switch
the
power
on
at
the
desired
time)
(to
switch
the
power
on
at
the
desired
time)
6)
Set
the
Timer
Standby
Selector
to
‘RECORD’.
7)
Set
the
Timer
Standby
Selector
to
“‘PLAY”
The
power
will
be
turned
on,
and
recoding
will
begin
at
the
The
power
will
be
turned
on
and
playback
will
begin
at
the
preset
time.
preset
time.
®Refer to the table below for the cassette tape to be used.
RT-30 (C-30) 15 minutes
RT-60 (C-60) 30 minutes
RT-90 (C-90) 45 minutes
Note:
Following use, be sure to set the Timer Standby
Selector to the ‘‘OFF” position. When the selector is
left at the “RECORD” position, if a tape with intact
record prevention tabs is inserted in the unit and the
Power Switch is set to ‘= ON”, the unit will enter the
recording mode, and the tape’s contents may be
erased by mistake.
AC Power
Outlet
AC OUTLET
—15—