Panasonic RX-C52 - Power Source; AC Power Operation

POWER SOURCE
m@ Battery Operation
1) Open the Battery Compartment cover as shown in the
figure.
2) Insert 8 “‘D” size (Panasonic UM-1 or equivalent)
batteries into the battery compartment, making sure that
the proper polarities are maintained, and that the
batteries are installed in the specified numerical order.
3) Replace the compartment cover.
eBattery removal (lower side)
Remove the batteries as shown in the figure.
eBattery life
When the batteries are weak, the tape speed will slow down,
the sound will become distorted, and the volume will
decrease.
ePress the Power Switch to “m= ON”.
ePress the TAPE Button (FUNCTION).
Press the Forward Button or Reverse Button.
elf the Power/Battery Check Indicator goes out or dims,
replace all batteries with new ones.
POWER/BATT
\ Cy.
7 I N
POWER/BATT
Note:
If the unit does not enter the playback mode even
when the Forward or Reverse Button is pressed, the
batteries are no good, replace all batteries with new
ones.
@ AC Power Operation
eBe sure to select AC voltage before applying power.
1) First, check the AC Voltage Selector to insure that it is
set to the voltage which corresponds to your household
AC voltage. If not, select the proper voltage by inserting
a small screwdriver into the slot provided and turning the
screwdriver until the desired voltage appears through the
opening.
200
iv
220
200-220 V | 230-250 V
a
iv
15
110-115 V
2) Connect the accessory AC power cord to the AC Socket
in the unit and your household AC power outlet. Upon
plugging the power cord into the AC Socket, the unit will
automatically switch from battery to AC operation.
115-127 V
AC power outlet
+
AC power cord
If using AC voltage other than 110-127 V, it may be
necessary to use an adaptor plug.
Car Battery Operation
insert the plug of the car adaptor cord into the DC Input
Jack.
Plug the opposite end of the cord into the cigarette lighter
socket in your car.
Upon plugging the car adaptor cord into the DC Input
Jack, the unit will automatically switch from internal
battery to car battery operation.
2)
@oc IN 13.2 V
£(C24)
Cigarette
lighter
Car
adaptor
socket
Use only Panasonic
car adaptor, RP-952
Note:
For the connection of an adaptor cord, follow the
instructions provided with the cord.