Panasonic RX-C52 - Page 8

RADIO
1) Press the Power Switch to “m= ON”.
The Power/Battery Check Indicator will light.
2). Press the RADIO Button (FUNCTION).
3)
Set
the
Band
Selector
to
the
desired
radio
band
(AM
or
FM).
4)
Tune
in
your
favorite
station
using
the
Tuning
Control.
5)
Set
the
FM
Mode
Selector
to
“
STEREO”
or
“m=
MONO”.
6)
Adjust
the
Volume,
Balance,
Bass
and
Treble
Controls.
7) The radio can be turned off by setting the Power Switch
to ‘MH OFF/SLEEP”.
Notes:
eTo receive FM stereo broadcasts, set the FM Mode
Selector to ‘EE STEREO”. The FM Stereo Indicator
will light during stereo broadcasts.
elf FM stereo reception is poor (excessive noise, FM
Stereo Indicator flickers), set the FM Mode Selector
to
‘=
MONO”.
This
will
reduce
the
noise
and
provide
clear
reception;
however,
the
broadcast
will
not
be
heard
in
stereo
elf the tape operation buttons are pressed while you
are
listening
to
a
radio
broadcast,
the
sound
and
Line Output may be temporarily interrupted.
m@ FM AFC
This set uses an Automatic Frequency Control (AFC) circuit
which locks the tuned station during FM and FM stereo
reception. This assures additional stability without frequen-
cy drift.
MLevel Meter
The
Level
Meter
lights
to
indicate
the
source
level
in
each
mode:
radio,
tape
playback
and
recording,
and
even
when
using
the
unit
as
an
amplifier
with
external
sound
sources.
@ Antennas
FM:
@Pull out the Telescopic Antenna and adjust its length and
angle for optimum reception.
On,
AM:
eThe sensitive ferrite core antenna inside the set will
provide excellent AM reception in most areas. For opti-
mum reception, turn the set in the direction which gives the
best results, since the ferrite core antenna is directional.
3000 twin lead ;
Matching
transformer
(300Q—75Q)
Shield wire
75Q coaxial cable
Inner conductor
Note:
If the antenna is connected with 75Q coaxial cable instead
of 3009 twin lead, the matching transformer is not required.
eHow
to
Connect
the
Antenna
Wire
to
the
Terminals
2 Paes
Push and
ib
Insert wire
8
Insert wire
or