Panasonic RX-ES25

Listening in
ROTS183
| The Radio |
Preparation: (when using batteries) Press [keas ).
A Normal tuning
i Press [TUNER BAND] to select “FM” or “AM”.
(Unit comes on when using AC power.)
Each time you press the button:
AM <> FM
2 Press [ REW/-/<@<4 ] or [ >/+/FF ] to select a sta-
tion.
A ” is displayed during FM stereo broadcasts.
EJ Press [+, - VOLUME] to adjust the volume.
B Using auto scan
Remote control onl
You can search for a station by listening to all tuned-in stations for 8
seconds each.
1 Press [TUNER] to select “FM” or “AM”.
2 Press [AUTO SCAN].
Auto scan starts.
3 Press [AUTO SCAN] when you find the desired
station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
(ef If noise is excessive in FM
Remote contro! onl
Press [FM MODE/BP] to display “(ONO)”.
Monaural sound is selected (“ ” goes off) and noise reduces when
reception is weak.
Press [FM MODE/BP] again to cancel the mode.
Auto-tuning
Press and hold [REW /—/ <@d] or D> / + / FF] until the frequency
starts changing rapidly.
The frequency stops when it finds a station. (Interference may also
cause it to stop. Start auto-tuning again if this occurs.)
To stop auto-tuning
Press [REW / -—/ t) or [> / + / FF).
E To improve reception
FM: Change the length and direction of the antenna.
AM: Change the facing of the unit.
¢ AM reception is briefly interrupted if [4 DECK] is pressed.
* To improve reception when using the unit in a building or vehicle,
use it near a window.
To receive FM broadcasts allocated in 0.1MHz
Main unit only
First press [TUNER BAND) to select “AM”. Now, press and hold
[TUNER BAND]. The display changes in a few seconds to show the
current lowest FM frequency. Continue to hold down the button.
The minimum frequency changes and the step is changed at the
same time. Changing the step erases all preset stations.
Repeat the above to change the step back.