Panasonic RX-ES25

i nn a Aa- e =d
| 5 il a) ky a The Play and Record Timer
You can set the timer to come on at a certain time to wake you up
| — {play timer) or to record a radio station (record timer).
Preparations:
Turn the unit on and set the clock. (=> page 9)
g * For play timer, prepare the music source (tape/CD/radio) for lis-
[S CSJ tening, and set the volume.
O = e For record timer, check the cassette's erasure prevention tab {wb
page 16: EJ) and load the cassette with the side for recording facing
up. Tune to the radio station (= page 10 to 11), and set the volume.
Setting the start and finish times
Press [CLOCK/TIMER] to select the desired timer
function.
Each time you press the button:
| Clock —> -ON @PLAY< — -@PLAY OFF <
FOR RECORD TIMER p |
riginal display <- -OREC OFF- <- [ON OREC.
Fy ha ON ©PLAY: to set the play timer
Sle Pas. ve ON ©REC: to set the record timer
l Proceed to step FJ before these indicators stop flashing
{about 10 seconds).
2 © Turn [TIME/PRESET TUNE --CD SKIP ~-] to set
the start time.
@ Press [CLOCK/TIMER].
|
E] @ Turn [TIME/PRESET TUNE --CD SKIP --] to set
the finish time.
| @ Press [CLOCK/TIMER].
The start and finish times are now set.
Turning the timer on
4 Press [OPLAY/REC] to display the timer indicator.
Each time you press the button:
C @PLAY — ©REC — no display (off) ~]
l ©PLAY: to turn the play timer on
i REC: to turn the record timer on
! (The indicator doesn’t appear if the start and finish times
haven't been set.)
“E” appears if the clock hasn't been set.
5 | Press [EME] to turn the unit off.
The unit must be off for timer to operate.
The record timer comes on about 30 seconds earlier than the
set time.
Timer E
To cancel the timer
Press [OPLAY/REC] when the unit is on to clear the timer indica-
tors from the display.
| (The timer comes on at the set time everyday if the timer is on.)
To check the settings (when unit is off)
Press [CLOCK/TIMER).
The settings are shown in the following order:
Start time, Finish time —» Music source —> Volume — Original display
To change the settings (when unit is on)
To change the times
Do steps E, FJ, EJ, and EJ.
To change the source or volume
1. Press [OPLAY/REC] to clear the timer indicator.
2. Make changes to the source or volume.
| 3. Do steps EJ to Kj.
You can enjoy your desired source after you have set the timer.
Turn the unit off before the timer’s start time.
| The play and record timers cannot be used together.
RQT5183 D ee Care (eee et ae