Panasonic RX-ES25 - Recording CDs: ALL-REC Mode; ALL-REC Recording Procedure; Handling Interrupted Recordings

(j
| Recording CDs |
Records the whole CD or selected tracks. When the tape finishes
before CD, recording and CD pauses for you to resume recording on
the opposite side.
Preparation: Insert a CD (m= page 12).
T Press [E TAPE/CD] to switch to CD mode.
2 Press [CD REC MODE] to display “ALL-REC”.
Each time you press the button:
ALL-REC —> 1-REC — OFF
p a eI
The display shows the tape length needed.
“C ——-—— indicates the tape needed exceeds 100 minutes.
You can still record, but some tracks may not be recorded if the
tape isn’t long enough.
3 Load a cassette with the side for recording facing
up.
4 Press [0/1] to start recording.
The unit rewinds the tape, records 10 seconds of silence, and
then starts recording.
To stop recording
Press [M TAPE/CD]. The CD also stops.
If a track is interrupted at the end of the side facing up
Recording and CD pauses.
To record the track agai the o ite side
1. Press [4 DECK], flip the cassette, and insert it.
2. Press [@/If).
The unit records 10 seconds of silence, and resumes recording
from the beginning of the cut-off track.
To record selected tracks
© Program tracks (mẹ page 14).
(2) Do steps FJ to Ej.
You cannot use ALL-REC with random play and repeat play (=> page
13).
Recording |
17
RQT5183