Panasonic RX-ES25

Listening _
ROQT5183
TAPE “CO
Programmed track
Programmed track
Play sequence
Play sequence
CDs
Program play
Select up to 36 tracks to play in the order you choose.
On the main unit
Preparation: Press [IB TAPE/CD] to switch to CD mode.
Turn (TIME/PRESET TUNE --CD SKIP —] to select
the track.
A Press [*MEMORY-CLEAR].
Repeat steps E and FJ to program other tracks.
3! Press [P/i CD] to start play.
On the remote control
Preparation: Press [M] to switch to CD mode.
[1] Press [PGM/- CLEAR].
j ” appears on the display.
[2] Enter the track number with the numbered but-
tons.
For tracks numbered 10 and over, press [210] then the two
digits.
Repeat this step to program other tracks.
[3] Press [CD] to start play.
The program remains intact even if play is stopped or the unit is
turned off. “Cd-P” appears when play is stopped to indicate the con-
tents are in the memory.
To cancel
Press and hold [MEMORY = CLEAR] (remote control: [PGM/
œ CLEAR)) in the stop mode until “CLEAR” is displayed.
The mode is also cancelled if the CD tray is opened,
“FULL” is displayed
If 36 tracks have already been programmed.
“~—:— —” is displayed
If the total play time of the program exceeds 100 minutes.
You can still program and play tracks.
E3 To check the program contents (while “Cd-P” is dis-
played)
Tum [TIME/PRESET TUNE -—CD SKIP ~-~].
On the remote control
Press [xt / V] or [A / m].