146
12.2.1.5 Mounting
1. Remove the bottom case.
Insert the driver and slightly turn.
*Do not insert the screw driver too deep. Doing so may cause the claw to be broken.
Attention
Mounting the bottom case
o Tighten the screws securely until the screw heads touch the bottom case.
(Otherwise, loose screw heads may hit the PCB and cause malfunction when mounting the top case.)
o Do not over-tighten the screws.
(The bottom case may be deformed, resulting in fall of the unit.)
Connecting the remote control wiring
o Arrange the wires as shown in the illustration for ⑥ in step 2 and ⑤, avoiding unnecessary wires being
stored in the case.
o Avoid the wires touching parts on the PCB.
o Avoid the wires coming in contact with the metallic object protruded from the PCB.
(Caught wires may destroy the PCB.)
Mounting the top case
o Do not push the top case with excessive force.
(Doing so may cause the protrusions of the bottom case to hit and destroy the PCB.)
To Next Page
Loading...
