Panasonic S-71WF3E - Page 147

147
2. Mount to the wall.
 Exposed type
Terminal board
150 mm
6 mm
Bottom case
(Back side)
Top case
(Back side)
Claw
(2 places)
Screw
(supplied)
Hole for
screw
Claw (2 places)
①
Make 2 holes for screws using a driver.
②
Mount the bottom case to the wall.
③
Cut here with a nipper and remote the burr with a file.
④
Remove the sheath. Approx. 150 mm
⑤
Remove the coating. Approx. 6 mm
⑥
Connect the remote control wiring.
 Make sure the wiring connection is in the correct direction.
 Arrange the wires along the groove of the case.

A
void the wire bein
g
cau
g
ht.
⑦
Mount the top case.

A
li
g
n the claws of the top case and then ali
g
n the claws of the bottom case.
 Embedded type
Claw
(2 places)
Screw
(supplied)
Hole for
screw
Claw (2 places)
Terminal board
Bottom case
(Back side)
Top case
(Back side)
50 mm
6 mm
①
Make 2 holes for screws using a driver.
②
Mount the bottom case to the wall.
 Pass the wire throu
g
h the hole in the centre of the bottom case.
③
Remove the sheath. Approx. 50 mm
④
Remove the coating. Approx. 6 mm
⑤
Connect the remote control wiring.
 Make sure the wiring connection is in the correct direction.

A
void the wire bein
g
cau
g
ht.
⑥
Mount the top case.

A
li
g
n the claws of the top case and then ali
g
n the claws of the bottom case.