152
Embedded type
Preparation: Make 2 holes for screws using a driver.
13
2
Connect the remote control wiring.
Mount the top case.
Align the claws of the top
case and then align the
claws of the bottom case.
Avoid the
wire being
caught.
Claw
(2 places)
Screw
(Supplied)
Hole for
screw
Claw
(2 places)
Mount the bottom case to the wall.
Pass the wire through the hole in the centre
of the bottom case.
Remote controller
terminal board
Remove the coating. Approx. 6 mm
Make sure the wiring connection
is in the correct direction.
Bottom case
(Back side)
Top case
(Back side)
To Next Page
Loading...
