158
12.2.2.7 Test Operation
1 Press and hold the 3 buttons for
4 seconds or more simultaneously.
, , ►
2 Select [Test run].
▲ ▼ →
3 Select [ON].
(The unit enters the test operation mode. Then, [TEST] turns on.)
▲ ▼ →
Press
.
4 Perform the test operation.
5 Finish the test operation.
Perform step 1 and 2, and then select [OFF] in step 3. ([TEST] display disappears.)
● The test operation can be performed in Heat or Cool mode.
● Temperature cannot be changed.
● The test operation mode is automatically turned off in 60 minutes. (To prevent continuous test operation)
● Outdoor units do not operate for approx. 3 minutes after the power is turned on or operation is stopped.
Attention
● Do not use this mode for purposes other than the test operation.
(To prevent overload of the units)
● Read the installation instructions supplied with the units.
To Next Page
Loading...
