13
RQT5908
Preparations
Customizing your receiver
If you allow about 10 seconds to elapse between settings, the
procedure is canceled, all settings are returned to how they were,
and the previous display is restored. Begin again if this occurs.
1 Press [POWER, 8].
2 Press [DSP SOUND MODE] and
[SFC MODE] at the same time.
3 Press [DSP SOUND MODE] to select
the item you want to change.
Each time you press the button:
SIZE
/
DISTANCE
/
FILTER
/
DR COMP
/
D-INPUT
/
DIMMER
↑
4 Change the settings (
aa
below).
Repeat steps 3 and 4 to complete the necessary
settings.
5 Press [DSP SOUND MODE] and
[SFC MODE] at the same time.
Changing the settings
SIZE
11
Press [SFC MODE] to select the speaker you want to set.
Each time you press the button:
FRONT / CENTER / SURROUND / SUB-WFR (Subwoofer)
↑
22
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
FRONT: SMALL ,/ LARGE
CENTER and SURROUND: NONE ,/ SMALL ,/ LARGE
SUB-WFR: NO ,/ YES
33
Repeat
11
and
22
to change other SIZE settings.
DISTANCE
11
Press [SFC MODE] to select the speaker you want to set.
Each time you press the button:
FRONT / CENTER / SURROUND
↑
22
Turn [INPUT SELECTOR] to set the distance.
33
Repeat
11
and
22
to change other DISTANCE settings.
FILTER
Turn [INPUT SELECTOR] to set the cut-off.
When you turn the selector:
100 ,/ 150 ,/ 200
DR COMP
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF ,/ STANDARD ,/ MAX
D-INPUT
11
Press [SFC MODE] to select the input position you want to set.
Each time you press the button:
CD COAX / DVD OPT2 / TV OPT1
↑
These are the factory settings. Actual displays depend on the
changes you make. If you change one setting, the other
corresponding setting will also change.
22
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
COAX ,/ OPT1 ,/ OPT2
↑ ↑
33
Repeat
11
and
22
to change other D-INPUT settings.
DIMMER
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF ,/ ON
Basic steps
To Next Page
Loading...
