17
RQT5908
Operations
Enjoying the sounds
1 Press [POWER, 8].
2 Press [SPEAKERS] to turn on
SPEAKERS.
3 Turn [INPUT SELECTOR] to select the
input source.
To switch between analog and digital input (CD,
DVD, and TV)
Press [DIGITAL INPUT].
Each time you press the button:
ANALOG ,/ DIGITAL
The indicator lights when you select “DIGITAL”.
Once you have set the mode for a source, that mode is
engaged whenever you select that source.
4 Select the DSP sound mode.
11
Press [DSP SOUND MODE].
The indicator corresponding to the mode lights.
Select the mode appropriate to the source (\ pages 15–16).
22
When you select “SFC”
Press [SFC MODE].
Once you have set the mode for a source, that mode is
engaged whenever you select that source.
5 Start playing the source.
Refer to the equipment’s instructions for details.
6 Adjust the volume.
When you finish listening
Be sure to reduce the volume and press [POWER, ^/l] to switch the
unit to standby.
For your reference
¡ If you are using a VCR and you select TAPE, CD or TUNER
The picture will remain on the screen.
¡ The signal format indicators
The following indicators light depending on the source you are
playing.
%DIGITAL
Dolby Digital Sources
%PRO LOGIC
Analog sources in SURROUND mode
Digital sources with PCM signals in SURROUND mode
Dolby Digital sources that contain Dolby Pro Logic in
SURROUND mode
¡ The program format indicators (L, C, R, LS, S, LFE, RS)
The program format indicators light up to indicate the channels
contained in the digital input signal. They do not light when input
is analog.
L: Front channel (left)
C: Center channel
R: Front channel (right)
LS: Surround channel (left)
RS: Surround channel (right)
S: If the surround channel is monaural.
LFE (Low Frequency Effect): Deep-bass effect.
To Next Page
Loading...
