Panasonic SA-HT833VP

Step 2: Release the catches.
1. Turn off by pressing power SW in the body.
2. Unplug AC power cord after the indication of [BYE], then
disassemble the body.
16.14.1. Gear for servicing information
· This unit has a gear which used for chacking items
(open/close of disc tray, up/down operation of traverse unit
by manually) when servicing. (For gear information, that is
described on the items for disassembly procedures.)
· For preparation of gear (for servicing), perform the
procedures as follows.
· In case of re-servicing the same set, the “ gear for servicing”
may be took off because it had been used. So, the “gear for
servicing” must be stored.
1. Remove the gear attached to top cover of CD loading
mechanism.
2. Insert the hexagonal wrench (2.5mm) into the gear.
16.12. Disassembly of Front Panel B
P.C.B.
· Follow the (Step 1) to (Step 2) of item 16.3
· Follow the (Step 1) to (Step 2) of item 16.4
Step 1: Release the catches and remove the Volume Knob.
Step 2: Remove 6 screws.
3. Disassemble the body, and take out CD loading
mechanism.
4. Perform disassembly according to the following procedure
for disassembly.
16.14.2. Replacement of traverse deck
· Follow the (Step 1) - (Step 2) of Item 16.3.
· Follow the (Step 1) - (Step 2) of Item 16.4.
· Follow the (Step 1) - (Step 3) of Item 16.6.
16.13. Procedure for removing CR16 mechanism (Precaution)
16.14. CR16 mechanism disassembly procedure
43
SA-HT833VP