21
Operations
RQT7523
Preset tuning
Select “TUNER FM” or “TUNER AM”.
Selecting preset channels (On the remote control)
When using the numbered buttons
To select a two digit number e.g. 21:
[ ≧ 10, ENTER] → [2] → [1]
Presetting stations.
(á below, “Automatic presetting” or “Manual presetting”)
Select PRESET tuning mode.
(á page 20, “Select MANUAL or PRESET tuning mode”)
Select the preset channels.
Hold down the button to change channels faster.
Multi control tuner settings
Enter Multi
control.
Automatic presetting
Preparation:
First, set the channel reception
to FM 87.9 MHz or AM 530 kHz.
Preset channels that are
automatically assigned by this
unit are:
FM: 1 to 30
AM: 21 to 30 (FM stations are
replaced if any were preset in
these channels.)
1. Select.
2. Select.
3. Select.
Main menu is displayed.
(Multi control menus and
factory settings á page 28)
Presetting
stations.
• During automatic presetting, the memory indicator ( ) flashes and the
frequency scrolls. The memory indicator and channel numbers are
displayed for a second when a station is preset.
• The last station to be preset is displayed when presetting finishes.
Manual presetting
1. Select. 2. Select.
3.Select the channel.
• “STORED” is displayed.
Preparation:
Set the station signal you want
to set as a preset.
Preset the stations one at a time.
• FM stations can also be preset
in the MONO mode.
• To continue presetting, press [TUNE 2 or 1] to tune another station from
step .
For your reference
Even if the AC power supply cord is disconnected from the household AC outlet, the stations remain in the
memory for approximately two weeks.
To finish settings
1. Press [MULTI CONTROL]
several times to select
“EXIT”.
2. Press [INPUT SELECTOR].
SPEAKERS
AB
POWER
8
6.1CH DECODING
VCR 2
PHONES
^
MULTI CONTROL
INPUT SELECTOR
VOLUME
DOWN UP
PUSH ENTER
BI-AMP
BI-WIRE
VIDEO IN
AUDIO INLR
S-VIDEO IN
TUNE
2
TUNE
1
MULTI CONTROL
PUSH ENTER
INPUT SELECTOR
To Next Page
Loading...
