30
SQT0935
Setup menu
1 Press [SETUP] repeatedly to select
the setup item.
2Press [4][3] repeatedly to select
the desired setting and then press
[OK].
DIMMER
Dims the display after
5 seconds of inactivity.
ON
OFF
BEEP
A beep sounds when you
touch the switch on the main
unit or when you turn the unit
on/off.
≥ This works during muting as
well.
ON
OFF
AUTO POWER
DOWN
The main unit automatically is
turned off if there is no audio
input and when you do not
use it for approx. 20 minutes.
ON
OFF
≥ When this is set, the display
shows “P.OFF 1” to indicate that
the main unit will turn off in
approximately 1 minute.
≥ If “BLUETOOTH STANDBY”,
“VIERA LINK” or “NET STANDBY”
is set to “ON”, this function will
also be set to “ON”. To change the
setting, set “BLUETOOTH
STANDBY”, “VIERA LINK” and
“NET STANDBY” to “OFF”.
(> 30, 31)
– “AUTO POWER DOWN” is not
indicated on the display when
“BLUETOOTH STANDBY”,
“VIERA LINK” or “NET
STANDBY” is set to “ON”.
VOL
LIMITATION
Sets the volume limit to 50
when you turn on the main
unit although the volume is
set to above 50 before it is
turned off.
ON
OFF
BLUETOOTH
STANDBY
This function allows you to
connect a paired Bluetooth
®
device when the main unit is
in standby mode.
ON
OFF
The main unit will be turned
on automatically when you
connect a paired Bluetooth
®
device.
≥ If this function is set to “ON”, the
standby power consumption will
increase.
LINK MODE
Change the transmission
mode to prioritise
transmission quality or sound
quality. Make sure that the
Bluetooth
®
device is not
connected (“BLUETOOTH
READY” is indicated on the
display).
MODE 1
: Emphasis on
connectivity.
MODE 2: Emphasis on sound
quality.
VIERA LINK
Turn on the VIERA Link
function.
ON
OFF
Select “OFF” when your
HDAVI Control device does
not work correctly with this
system.
≥ ARC will be disabled. Connect an
optical digital audio cable.
≥ Turn off all connected devices and
then turn them on again after
changing the setting.
REAR
PAIRING
You can add SC-ALL2 (sold
separately) to this system as
rear surround speakers.
≥ For details, refer to “Rear
surround” (> 32)
REAR
SPEAKER
You can select to have 5.1 ch
output with rear surround
speakers (ON) or 3.1 ch
output without rear surround
speakers (OFF).
ON
OFF
SC-ALL70T-SQT0935.book 30 ページ ２０１５年４月２８日 火曜日 午前１０時５分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
