Panasonic SC-BT205 - Speaker connections

9
RQT9445
Speaker connections
Turn off all equipment before connection and read the appropriate operating instructions.
Do not connect the AC mains lead until all other connections are complete.
Setup example
[BT205] : The speaker cables are attached to the speaker stands.
Connect to the terminals of the same colour.
Use of the speaker cable stickers is convenient when making cable connections.
OPTICAL
2(STB) 1(TV)
L
R
DIGITAL IN
COMPONENT
VIDEO OUT
VIDEO
OUT
Y
AUX(TV)
P
R
P B
SPEAKERS
AV OUT
CENTER
3 Ω 3 Ω
FRONT
3 Ω
SURROUND
AC IN
R
L
5
2
1
R
L
4
3
-
TRANSMITTER
DIGITAL
Main unit
+
FM ANT
75Ω
WOOFER
6
3 Ω
SUB-
[BT200]
Speaker cable for front
speaker (L) (White)
Sheet of speaker cable
stickers
[BT200]
Speaker cable for front
speaker (R) (Red)
[BT200]
Speaker cable for surround
speaker (L) (Blue)
[BT200]
Speaker cable for surround
speaker (R) (Grey)
Speaker cable for centre
speaker (Green)
≥Don’t use a front speaker as a surround speaker or vice versa. Verify the type of speaker with label on the rear label
of the speaker before connecting the appropriate cable.
≥Pay attention to the type of speaker and the connector colour when you place the speakers.
Main unit
Surround speaker (L )
SPEAKERS
+
-
R
L
CENTER
3 Ω
3 Ω 3 Ω
SUB-
WOOFER
FRONT
6
5
2
1
R
L
3 Ω
SURROUND
4
3
1
FRONT
Lch
Push!
e.g. Front speaker (L)
e.g.
Speaker cable sticker (included)
: White
: Blue
GREY
SURROUND
(R
ch)
BLUE
SURROUND
(L
ch)
RED
FRONT
(R
ch)
WHITE
FRONT
(L
ch)
PURPLE
SUBWOOFER
GREEN
CENTRE
Insert the wire fully,
taking care not to insert
beyond the wire
insulation.
Be careful not to cross
(short-circuit) or reverse
the polarity of the
speaker wires as doing
so may damage the
speakers.
Do not
≥Match the connector colour and the type of speaker as shown above.
≥Extending the speaker cables may damage the speakers and sound quality will negatively be affected.
NOTE
Getting started
SCBT200&205EB_RQT9445-B.book 9 ページ ２００９年４月１５日 水曜日 午後２時１５分