Panasonic SC-HC397

25
8.11. Disassembly of Motor P.C.B.
• Refer to “Disassembly of Front Ornament Unit (L) & (R)”
• Refer to “Disassembly of Front Panel Block”
Step 1 : Release 5P wire from slots.
Step 2 : Remove screw.
Step 3 : Remove screw.
Step 4 : Lift up Motor P.C.B..
Caution : During assembly, avoid using electric screw-
driver to prevent overrun for [ ] type screw.
Step 5 : Detach 5P wire at connector (CN931) on Motor P.C.B..
Step 6 : Desolder pins on solder side of Motor P.C.B..
Step 7 : Remove Motor P.C.B..
8.12. Disassembly of Gear Block &
Arm Spring (Top)
• Refer to “Disassembly of Front Ornament Unit (L) & (R)”
• Refer to “Disassembly of Door Unit”
• Refer to “Disassembly of Front Panel Block”
Step 1 : Push up to release Door Holder as arrow shown.
Caution : During assembly, ensure Door Holder is lock as
shown.
Step 2 : Release 5P wire from slots.
Step 3 : Detach 5P wire at connector (P942) on Bridge P.C.B..