RQT8596
7
Simple Setup
4 Secure the speaker to the stand.
5 Connect the speaker cable.
∫ Preventing the speakers from falling
≥ You will need to obtain the appropriate screw eyes to match the
walls or pillars to which they are going to be fastened.
≥ Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result in damage to the wall or speakers.
Speaker
Stand
Screw
Tighten securely.
Ensure the speaker cable is
centered in the groove.
_: White
`: Blue
Push!
Press the speaker cable
into the groove.
Insert the wire fully.
Assembled!
String (not included)
Thread from the wall to the
speaker and tie tightly.
Rear of the speaker
Wall
Approx. 150 mm
Screw eye
(not included)
Assembling the speakers
HT540En.book Page 7 Monday, February 20, 2006 2:03 PM
To Next Page
Loading...
