Reference
Operations
RQT9834
21
∫ To reduce the clear-mode dialog effect
When the dialog does not sound natural while the
volume is set low, it is possible to reduce the dialog
enhancing effect as follows:
While pressing and holding [TV] on the remote
control, press and hold [VOLUME s] on the main
unit for more than 2 sec.
A will blink once when the setting is changed.
≥ To reset the setting, return to the factory preset. (> right)
∫ To turn off VIERA Link “HDAVI Control”
When “HDAVI Control” compatible equipment does
not work well with this system, for example, it is
possible to turn off this function as follows:
≥ When VIERA Link is turned off, the ARC function is not
available. Be sure to connect the optical digital audio cable.
(> 14)
1 While pressing and holding [MUTE] on the
remote control, press and hold [VOLUME s]
on the main unit for more than 2 sec.
A will blink once when the setting is changed.
2 After the setting has changed, turn off all the
connected devices and then turn them on again.
To reset the setting, return to the factory preset. (> right)
∫ To turn off the volume limitation
If a state of the lowered volume disturbs you every
time the main unit turns on, for example, it is
possible to turn off this function as follows:
While pressing and holding [MUTE] on the remote
control, press and hold [VOLUME i] on the main
unit for more than 2 sec.
A will blink once when the setting is changed.
To reset the setting, return to the factory preset. (> right)
Reference
Troubleshooting
Before requesting service, make the following
checks. If you are in doubt about some of the check
points, or if the solutions indicated in the following
guide do not solve the problem, consult your dealer
for instructions.
No power.
≥ Insert the AC mains lead securely. (> 16)
≥ After turning the main unit on, if the indicators
blink and the main unit immediately turns off,
unplug the AC mains lead and consult your
dealer.
The remote control does not work properly.
≥ The battery is depleted. Replace it with a new
one. (> 7)
≥ It is possible that the insulation sheet has not
been removed. Remove the insulation sheet.
(> 7)
≥ It may be necessary to set the code of the remote
control again after changing the battery of the
remote control. (> 20)
≥ Use the remote control within the correct
operation range. (> 7)
The “TV” indicator blinks.
Remove the AC mains lead and consult your
dealer. If there are any other indicators blinking, be
sure to inform your dealer about the blinking
indicators.
TV
BD/DVD
DTS PCMD
A
To return to the factory preset.
While the main unit is on, press [Í/I] on the main
unit for more than 4 sec.
(All the indicators will blink twice when this
system is reset.)
If this system does not operate as expected,
returning the settings to the factory preset
may solve the problem.
≥ The remote control code will return to “1” when
this system is returned to the factory preset. To
change the remote control code, refer to page
20.
General operation
SC-HTB527EGEB_RQT9834-B.book 21 ページ ２０１２年１２月１０日 月曜日 午前１１時２９分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
