Reference
RQT9834
23
The dual audio cannot be changed from main to
secondary.
If the audio received from the connected device is
not “Dolby Dual Mono” or the output setting is not
“Bitstream”, the setting cannot be changed from
this system. Change the setting on the connected
device.
The volume is lowered when the main unit is
turned on.
If the main unit is turned off with the volume setting
in the greater half (above 50), the main unit will
automatically lower the volume to the middle (50)
when the main unit is turned on. (> 21)
The dialog is too persistent or the dialog does
not sound natural.
This system has a function to make the dialog
stand out when the volume is low. (> 21)
There is no audio.
The power of the main unit turns off
automatically.
(When the main unit detects a problem, a safety
measure is activated and the main unit
automatically switches to standby mode.)
≥ There is a problem with the amplifier.
≥ Is the volume extremely high?
If so, lower the volume.
≥ Is this system placed in an extremely hot place?
If so, move this system to a cooler place and wait
a few moments and then try to turn it on again.
If the problem persists, turn this system off and
remove the AC mains lead cord and consult your
dealer. Please be sure to remember the indicators
that were blinking and inform the dealer.
No power.
Ensure the AC mains lead of the active subwoofer
is connected properly.
After turning the subwoofer on, it immediately
turns off.
Unplug the AC mains lead and consult your dealer.
No sound from the subwoofer.
≥ Check that the active subwoofer is turned on.
≥ Check that the WIRELESS LINK indicator lights
green. (> 16)
The WIRELESS LINK indicator lights red and
green alternately.
Turn the subwoofer off, disconnect the AC mains
lead and then reconnect it.
Consult your dealer if the problem persists.
The WIRELESS LINK indicator lights red.
≥ There is no link between the main unit and the
active subwoofer.
jCheck that the main unit is turned on.
jEnsure that the digital transmitter is fully
inserted into the digital transmitter dock on the
main unit. (> 15)
jTurn the active subwoofer off and then back on.
Alternatively, turn the active subwoofer off,
disconnect the AC mains lead and then
reconnect it.
≥ Consult your dealer if the problem persists.
Unit care
∫ Clean this system with a soft, dry cloth
≥
When dirt is heavy, wring a cloth moistened in water
tightly to wipe the dirt, and then wipe it with a dry cloth.
≥ When cleaning the main unit, use a fine cloth. Do
not use tissues or other materials (towels, etc.)
that can fall apart. Small grains may get stuck
inside the main unit cover.
≥ Never use alcohol, paint thinner or benzine to
clean this system.
≥ Before using chemically-treated cloth, carefully
read the instructions that came with the cloth.
∫ To dispose or transfer this system
This system may keep the user settings information in the
main unit. If you discard the main unit either by disposal or
transfer, then follow the procedure to return all the settings
to the factory presets to delete the user settings. (> 21, “To
return to the factory preset.”)
≥ The operation history may be recorded in the memory of
the main unit.
Licenses
Active subwoofer
Manufactured under license from Dolby Laboratories.
Dolby, Pro Logic, and the double-D symbol are trademarks of
Dolby Laboratories.
Manufactured under license under U.S. Patent Nos: 5,956,674;
5,974,380; 6,487,535 & other U.S. and worldwide patents issued
& pending. DTS, the Symbol, & DTS and the Symbol together are
registered trademarks & DTS Digital Surround and the DTS logos
are trademarks of DTS, Inc. Product includes software. © DTS,
Inc. All Rights Reserved.
HDMI, the HDMI Logo, and High-Definition Multimedia Interface
are trademarks or registered trademarks of HDMI Licensing LLC
in the United States and other countries.
HDAVI Control
TM
is a trademark of Panasonic Corporation.
SC-HTB527EGEB_RQT9834-B.book 23 ページ ２０１２年１２月１０日 月曜日 午前１１時２９分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
