15
VQT5F34
ENGLISH
Clock and timers
This is a 24-hour clock.
1 Press [CLOCK/TIMER] to select “CLOCK”.
2 Within 20 seconds, press [3, 4] to set the time.
3 Press [OK].
Press [CLOCK/TIMER] to show the clock for a few
seconds.
Note:
• Reset the clock regularly to maintain accuracy.
• The clock is reset when there is a power failure or when the
AC mains lead is removed.
Except for Bluetooth
®
source
You can set the timer to come on at a certain time to:
• Wake you up (play timer)
• Record from the radio or the external equipment
(record timer)
Play timer and record timer cannot be used together.
Preparation
Set the clock.
1 Press [CLOCK/TIMER] to select “ PLAY” or
“REC”.
2 Within 10 seconds, press [3, 4] to set the start
time.
3 Press [OK].
4 Do steps 2 and 3 again to set the end time.
5 Press [3, 4] to select the source you want to
play or record and then press [OK].
6 For record timer
Press [3, 4] to select “MEMORY” or “USB B” to
keep the recording and then press [OK].
To start the timer
1 Prepare the audio source.
2 Press [PLAY/REC ] to select “ PLAY ON” or
“ REC ON”.
“ PLAY ON” or “ REC ON” is shown.
To cancel, press [PLAY/REC ] to select “TIMER OFF”.
The system must be switched off for the timer to
operate.
To check the settings
Press [CLOCK/TIMER] to select “ PLAY” or
“REC”.
Note:
• The play timer starts at a low volume and increases
gradually to the preset level.
• The record timer starts 30 seconds before the set time with
the volume muted.
• The timer comes on at the set time every day if the timer is on.
The sleep timer switches off the system after the set
time.
Press [SLEEP-AUTO OFF] to select the setting (in
minutes).
To cancel, select “OFF”.
Note:
• The play and sleep timer or the record and sleep timer can
be used together.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.
Sound and illumination
You can adjust the sound effect.
1 Press [SOUND] to select the sound effect.
2 Press [2, 1] to select the desired setting.
Preset EQ
Press [PRESET EQ]
(main unit:
[ PRESET EQ
])
to select desired preset.
Setting the clock
Play and record timer
• Play timer
Prepare the music source you want to listen to
(disc, USB, internal memory, radio or external
equipment) and set the volume.
• Record timer
Connect the USB device to (for USB
recording) and tune to the radio station or select
the external equipment.
Sleep timer
30 MIN
>
60 MIN
>
90 MIN
>
120 MIN
>
OFF
^=================n
Adjust the sound effect
• BASS/MID/TREBLE
-4 to +4
• SURROUND
“ON SURROUND” or “OFF SURROUND”
• INPUT LEVEL
(For AUX IN 4)
“NORMAL” or “HIGH”
Note:
Select “NORMAL” if the sound is distorted during
“HIGH” input level.
• SUPER WOOFER
“SW1”, “SW2”, “SW3” or “OFF”
• D.BASS
“D.BASS ON”, “D.BASS BEAT” or “D.BASS OFF”
Note:
D.BASS BEAT:This function emphasizes the
attack level of the drum beat and produces a
punchy sound.
• Depending on the type of a track, the effect may
be small.
15
SC-MAX370GS_eng_sch_rus_ukr.book 15 ページ ２０１４年３月１２日 水曜日 午後６時４９分
To Next Page
Loading...
