RQT6683
18
Listening operations
B
A
B
C
3
1
OPEN
OPEN
OPEN
Before recording
Types of tapes which can be recorded correctly
The system automatically identifies the type of tape.
NORMAL POSITION/TYPE I ✓
HIGH POSITION/TYPE II ✕
METAL POSITION/TYPE IV ✕
High position and metal position tapes can be used, but the
unit will not be able to record or erase them correctly.
Erasure prevention
The illustration shows how to remove the tabs to prevent re-
cording. To record on the tape again, cover as shown.
The effect of volume and sound quality on
recording.
These have no effect on recording.
They can be changed for playback.
To erase a recorded sound
1
Press [TAPE -] and then [STOP L, –DEMO].
2
Insert the recorded cassette with the tape facing in.
3
Press [[/ J REC].
Preparatory steps
Do these steps before each recording.
Wind up the leader tape so recording can begin
immediately.
Press [c OPEN], insert a cassette with the tape
facing in.
Make sure the cassette is fully inserted and close the lid by
hand.
A
B
Recording operations
Side A
Tab for side B Tab for side A
To re-record
Normal position tape
C
Side to be recorded
facing up
Insert inside the guides
To protect tapes against further recording
Adhesive tape
RQT6683(11-20).P65 1/13/03, 4:32 PM18
To Next Page
Loading...
Need help?
General
