Panasonic SD-253 - Page 17

1. Remove the "Faston" terminal from the heater.
2. Raise the two claws of the ground plate up with the flat-
blade screwdriver.
3. On the outside of the heater case, detach the three claws
that secure heater bobbin B.
4. Remove the screw securing heater bobbin A inside the
heater case Ass’y.
5. Pull the heater out of the heater case Ass’y.
Fig.18
No. Parts Name
1 Flat-blade screwdriver
2 Heater bobbin B
3 Ground plate
4 Claw
5 Angle Unit
6 Heater case Ass’y
Fig.19
No. Parts Name
1 Heater case Ass’y
2 Heater
3 Angle Unit
4 Heater bobbin B
5 Screw
6 Heater bobbin A
Caution:
Before attaching the ground plate to the heater, restore
the connector to its original shape so that it will firmly
attach to the heater.
3.12. Heater
17
SD-253