EasyManua.ls Logo

Panasonic SDR-H50 - Battery Insertion, Removal, and Safety; Connecting to AC Outlet; Inserting and Removing Battery Pack; Battery Safety Cautions

Panasonic SDR-H50
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
LSQT1346
1 Connect the AC cable to the AC adaptor and the AC outlet.
2 Insert the battery on the battery charger by aligning the arrows.
We recommend using Panasonic batteries. (l 7, 16)
If you use other batteries, we cannot guarantee the quality of this product.
Insert the battery until it clicks while paying attention to the direction of the
battery.
A Push the centre of the battery until it locks.
Be sure to set the mode dial to OFF and check
that the status indicator is off before removing
the battery.
Do not heat or expose to flame.
Do not leave a battery pack in an automobile
exposed to direct sunlight for a long period of
time with doors and windows closed.
Notice about the rechargeable battery
The battery is designated recyclable.
Please follow your local recycling regulations.
Inserting the battery
A
Removing the battery
While pressing button B, move C in the
direction of the arrow to unlock it and then
remove the battery.
Hold the battery with your hand so that it
does not fall.
C
B
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
Warning
Risk of fire, explosion and burns. Do not
disassemble, heat above 60 xC or incinerate.
SDR-H60&40EP-LSQT1346_eng.book 15 ペー 008年2月25日 月曜日 午後3時33分

Table of Contents

Related product manuals