Panasonic SV-AV30 - Power Supply; Using AC Adaptor; Charging the Battery

10
Power Supply
ª Using AC Adaptor
1 Connect the AC Adaptor to AC Main
socket.
2 Connect the DC Input Lead to the [DC IN
4.8V] socket on the SD Multi AV Device.
ª Charging the Battery
1 While holding the [ ] part, slide
it to remove the Battery Compartment
Cover.
2 Press the terminals of the battery onto
the terminals of the Battery
Compartment and set the battery.
≥Fit the battery with its label facing upward.
≥After the battery is set, close the cover.
3 Connect the AC Adaptor to AC Main
socket.
4 Connect the DC Input Lead to the [DC IN
4.8V] socket on the SD Multi AV Device.
≥Power Lamp 1 flashes, and Charging starts.
≥When recharging, turn the power of the SD Multi
AV Device off.
5 Wait until Power Lamp 1 goes off.
≥When recharging is completed, Power Lamp
goes off.
≥If the Power Lamp flashes quickly (or slowly) when
recharging, recharging is not normal. (l 55)
THE SOCKET OUTLET SHALL BE
INSTALLED NEAR THE EQUIPMENT AND
SHALL BE EASILY ACCESSIBLE.
1
2
DC IN 4.8V
1
2
DC IN 4.8V
3
4
1
AV30U.book10ページ２００３年４月２日 水曜日 午前１１時４０分