Panasonic SV-AV30 - Charge the Built-In Battery for Maintaining the Date Information; After Use

49
RECOFF
PLAY
Others
Charge the built-in battery
for maintaining the date
information
This built-in battery is used for the memory of date
and time. If [PRESS MENU TO SET CLOCK] is
displayed when the power is on, the built-in battery
may be exhausted. Charge using the following
procedure:
1 Take the battery out and plug in the AC
adaptor. (
l 10)
2 Turn the power off and leave the SD Multi
AV Device as it is for approx. 12 hours.
≥After recharging the built-in battery, adjust the date
and time. (l 17)
≥Even if the built-in battery is not run down, [PRESS
MENU TO SET CLOCK] is displayed at the time of
purchase.
After Use
1 Turn off the SD Multi AV Device.
2 Take out the Memory Card. (l 11)
3 Detach the power supply and retract the
LCD Monitor
.
4 Put the SD Multi AV Device into the
Wearable Carry Case.
DC IN 4.8V
1
2
AV30U.book49ページ２００３年４月２日 水曜日 午前１１時４０分