TC-L42E5X
21
7.9. Plate Metal Part Assembly
1. Place the gasket at the bottom of the metal parts, see figure 1.
2.
Place the metal parts in the positions indicated, insert the metal part guide pins into the holes on the panel, as shown in detail A.
3. Place the gasket on one side of metal part L, then cover it with 2 strips of 35 mm tape. See figure 2.
4. Screw in the positions indicated using the corresponding torque.
No. Part Num. Quant. Description
1 TUA5ZA03201 1 METAL_CH_FRAME_L
2 TUA5ZA04301 1 METAL_CH_FRAME_R
3 TEWB809 1 GASKET(T15 × W15 × L25)
To Next Page
Loading...
