Panasonic TC-P60VT60 - 3 D Eyewear Setup; Initial 3 D Eyewear Registration; Re-registering 3 D Eyewear; Viewing 3 D Content Settings

24
9.2.21. Work instructions for the Rubber
sheet for SS-Board
1. Rubber sheets are put between the board and rear cover
for EMC requirement and heat radiation. Confirm rubber
sheets were placed at each portion when assembling as
shown in figure.
9.2.22. Remove the SS2-Board
1. Disconnect the flexible cable (SS65 and SS67).
2. Remove the screws (×2 ) and remove the SS2-Board.
9.2.23. Remove the USB cable (A-WiFi)
1. Remove the screw (×1 ).
2. Remove the USB cable (A-WiFi).
9.2.24. Remove the Metal bracket bottom
1. Remove the screws (×6 , ×2 ) and the Metal
bracket bottom.
9.2.25. Remove the M8 nut metals
1. Remove the screws (×2 each) and remove the M8 nut
metals.
9.2.26. Remove the K-Board
1. Remove the screws (×2 ) and remove the LED panel
case.
2. Disconnect the connector (K10).
3. Remove the claw (×1 ) and remove the K-Board.
4. Remove the LED panel.