Panasonic TC-P60VT60 - Initial TV Setup; Powering On and Language Selection; Network and Channel Configuration; Touch Pad Controller Pairing

20
9.2.7. Remove the Rear cover
1. Remove the screws (×33 , ×2 ).
2. Remove the M8 caps (×4 ).
3. Remove the Rear cover.
9.2.8. Remove the AC inlet
Caution:
To remove AC inlet wait 1 minute after power was off for
discharge from electrolysis capacitors.
1. Disconnect the connector (P9).
2. Unlock the tape to free the cables.
3. Remove the screws (×1 , ×1 ) and remove the AC
inlet.
9.2.9. Remove the P-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for
discharge from electrolysis capacitors.
1. Unlock the hooks and the tapes to free the cables
2. Disconnect the connectors (P2, P6, P11 and P35).
3. Remove the screws (×5 , ×1 ) and remove the P-
Board.