Panasonic TH-103VX200W

To Next Page

To Previous Page

TH-103VX200W

6.1.2. CD mode

Select the CD mode by Up/Down button on the remote control at the front page of CAT mode and then press the [5] button on the

remote control more than 3 seconds.

Memory data change

To exit the CD mode, press the RETURN button on the remote control.

6.1.3. NW mode

Note :

To use the network function, set each [Network Setup] setting and make sure to set the [Control I/F Select] to [LAN].

Select the NW mode by Up/Down button on the remote control at the front page of CAT mode and then press the OK button on

the remote control.

To exit the NW mode, press the RETURN button on the remote control.

Panasonic TH-103VX200W - Page 12