2. Remove the screws (×3 ) and disconnect the relay
connector L, R.
3. Remove the Speaker L, R.
6.24. Remove the stand brackets.
1. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a table (covered), with the
plasma panel surface facing downward.
Spread a soft cloth or similar on the table for protection, so
the panel surface is not scratched.
2. Remove the stand bracket (left, right) fastening screws (×4
each) and remove the stand brackets (left, right).
6.25. Remove the C3-Board
1. Remove the flexible cable holder fastening screws (×8), and
disconnect the flexible cables (CB5, CB6, CB7, CB8).
2. Disconnect the couplers (C33, C42, C44), and disconnect
the flexible cables (C31).
3. Remove the screws (×3
), and remove the C3-Board.
6.26. Remove the C4-Board
1. Remove the flexible cable holder fastening screws (×8 )
and disconnect the flexible cables (CB1, CB2, CB3).
2. Disconnect the coupler (C43) and disconnect the flexible
cables (C41).
3. Remove the screws (×3
), and remove the C4-Board.
18
TH-42PV500E / TH-42PV500B / TH-37PV500E / TH-37PV500B
To Next Page
Loading...
