Panasonic TH-42PZ80U

20
7.12. Remove the Stand brackets
1. Remove the Plasma panel section from the servicing
stand and lay on a fiat surface such as a table (covered)
with the Plasma panel surface facing downward.
2. Remove the Stand brackets (L, R) fastening screws (×4
each) and remove the Stand brackets (L, R).
7.13. Remove the D-Board
1. Remove the A-Board unit. (See section 7.6.)
2. Disconnect the connectors (D3, D5 and D25).
3. Disconnect the flexible cables (D20, D31, D32 and D33).
4. Remove the screws (×4 ) and remove the D-Board.
7.14. Remove the C1-Board
1. Remove the A-Board unit. (See section 7.6.)
2. Remove the Stand bracket L. (See section 7.12.)
3. Remove the screws (×3 ) and Remove the Cabinet
mount metal.
4. Remove the DD-Heat-sink holder fastening screws
(×16 ).
5. Remove the DD-Heat-sink (×8).
6. Disconnect the flexible cables (CB1, CB2, CB3, CB4,
CB5, CB6, CB7 and CB8).
7. Disconnect the flexible cables (C10, C11 and C12).
8. Remove the screws (×5 ) and remove the C1-Board.