10
Input/Output Terminals
EXT SP(8Ω,20W[10W+10W])
1
2
3
4
8 9
10
11
13
12
5 6
7
EXT SP(8Ω,20W[10W+10W])
1
AC IN
Connect the supplied power cord to the wall outlet.
2
MAIN POWER SWITCH
Press to switch the main power on/off.
3
IR TRANSMITTER IN / OUT
Reserved for the wired connection of the IR control.
NOTE: If an optional IR receiver is connected to [IR
TRANSMITTER IN], this Display’s remote control
sensor will stop working.
4
SERIAL OUT / SERIAL IN
RS232C network input/output connection for the use of
loop-through function.
5
LAN
LAN control function for the use of remote control signal
from control center.
6
HDMI AV IN
Input the HDMI source of an AV device, or the DVI-D
output of a PC by using a DVI-HDMI cable.
7
DVI-D IN / DVI-I OUT
Digital video input and output connection.
8
PC IN
Input the PC source.
9
AUDIO IN 1
Input the PC audio source (3.5 mm stereo phone jack).
10
COMPONENT/VIDEO IN (BNC)
Input the component YPbPr source from external AV
device.
For VIDEO input, connect with CVBS cable from the video
output of your AV device to this Display’s Y input (an after-
market BNC-RCA adapter will be needed).
11
AUDIO IN 2 (RCA)
Input the audio source from external AV device.
12
AUDIO OUT (RCA)
Output the audio source connected from the AUDIO IN
jack to an external AV device.
13
SPEAKER OUT R/L -> EXT SP (8 Ω)
Output the audio to your external speakers.
To Next Page
Loading...
