19
Using Network Function
This display has a network function to control the network connected display with your computer.
NOTE:
• To use the network function, set each {LAN SETTING} setting and make sure to set the {SERIAL CONTROL} to {LAN}. (see
page 20, 28)
Network Connection
Display (main unit, rear)
Hub or broadband router
LAN cable (Shielded)
• Use the shielded Twist Pair (STP)
LAN cable.
NOTES:
• Make sure your broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use “Category 5 or above” LAN cable (not included).
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
To Next Page
Loading...
