27
TILING
With this function you can create a single large-screen matrix
(video wall) that consists of up to 25 sets of this Display (up
to 5-set each at the vertical and horizontal side).
EXIT MENU
:SEL +-:ADJ :RETURN :EXIT MENU
TILING
H MONITORS
V MONITORS
POSITION
FRAME COMP.
ENABLE
1
1
1
OFF
OFF
Example: 2 × 2 screen matrix (4 displays)
H MONITORS = 2 displays
V MONITORS = 2 displays
V MONITORS
H MONITORS
POSITION
Example: 5 × 5 screen matrix (25 displays)
H MONITORS = 5 displays
V MONITORS = 5 displays
POSITION
V MONITORS
H MONITORS
• H MONITORS - Select the number of displays on the
horizontal side.
• V MONITORS - Select the number of displays on the
vertical side.
• POSITION - Select the position of this Display in the
screen matrix.
• FRAME COMP. - Choose to turn the frame compensation
function on or off. If turned on, this Display will adjust the
image to compensate for the width of this Display bezels
in order to accurately display the image.
• ENABLE: Choose to enable or disable the Tiling
function. If enabled, this Display will apply the settings
in {H MONITORS}, {V MONITORS}, {POSITION}, and
{FRAME COMP.}.
NOTES: A setup of TILING can be set up for each input,
individually.
POWER ON DELAY
Select the delayed time until the power-on mode is activated
after the power is turned on manually or automatically. This
setting is useful in hiding start-up messages and powering on
the connected devices at different timings.
The options are: {OFF}, {2 SEC.}, {4 SEC.}, {6 SEC.},
{8 SEC.}, {10 SEC.}, {20 SEC.}, {30 SEC.}, {40 SEC.},
{50 SEC.}.
CONFIGURATION2 RESET
Reset all settings in the CONFIGURATION2 menu to factory
preset values.
CONFIGURATION3 menu
1
2
3
SET EXIT MENU
3
:SEL :NEXT
POWER SAVE
HEAT STATUS
SCREEN SAVER
:RETURN :EXIT MENU
SIDE BORDER COLOR
CONFIGURATION3 RESET
51
CONFIGURATION3
POWER SAVE
Set this Display to reduce the power automatically.
EXIT MENU
:SEL +-:ADJ :RETURN :EXIT MENU
POWER SAVE
RGB
VIDEO
ON
ON
• {RGB} - Select {ON} to let this Display enter power saving
mode with no signal detected from the HDMI, DVI, or PC
inputs after 30 seconds.
• {VIDEO} - Select {ON} to let this Display enter power
saving mode with no signal detected from the VIDEO or
DVD/HD inputs after 30 minutes.
HEAT STATUS
This function allows you to check the thermal status of this
Display at any time.
EXIT MENU
:RETURN :EXIT MENU
HEAT STATUS
COOLING FAN
OFF
TEMPERATURE:
SENSOR 1
SENSOR 2
35.7 C / 96.2 F
30.2 C / 86.3 F
To Next Page
Loading...
