29
LAN SETTING
Assign {IP ADDRESS}, {SUBNET MASK}, and {DEFAULT
GATEWAY} for this Display.
1
2
3
EXIT MENU
:SEL
DHCP CLIENT
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
:RETURN :EXIT MENU
OFF
+-:ADJ
ADVANCED OPTION
LAN SETTING
• DHCP - Choose to enable or disable the DHCP function. If
enabled, this Display will be assigned IP address, Subnet
mask and Default gateway automatically. If disabled, you
will be prompted to enter the following value manually.
INITIAL INPUT
Select the input source you want this Display to initiate each
time after turning power on.
CALIBRATION DATA SAVE
Save the data of color calibration executed and adjusted by
user at any timing.
CALIBRATION DATA LOAD
By read this data, PD will get back to state at the timing when
user executed color calibration and adjusted.
Note: The data that saved and loaded by CALIBRATION
DATA SAVE and LOAD, are below items.
- The adjustment data of white balance for each “COLOR
TEMPERATURE” (3000K to 10000K, and NATIVE, USER)
- “BRIGHTNESS” data when picture mode is in STANDARD
mode
- GAMMA data for each GAMMA curve.
ADVANCED OPTION RESET
Reset all settings in the ADVANCED OPTION menu to factory
preset values.
1. Press [SET] button to enter the submenu.
2. Press [ ] or [ ] button to select {YES}, and then press
[SET] button to do the reset.
EXIT MENU
SET
:SEL :RETURN:SET :EXIT MENU
ADVANCED OPTION RESET
NO
YES
FACTORY RESET
Reset all the settings in the OSD menus of {PICTURE},
{SCREEN}, {AUDIO}, {CONFIGURATION1},
{CONFIGURATION2}, {CONFIGURATION3}, and
{ADVANCED OPTION} to factory preset values.
1. Press [SET] button to enter the submenu.
2. Press [ ] or [ ] button to select {YES}, and then press
[SET] button to do the reset.
EXIT MENU
SET
:SEL :RETURN:SET :EXIT MENU
FACTORY RESET
NO
YES
To Next Page
Loading...
