Specifi cations
TH-58PF20ER TH-65PF20ER
Power Source 220 - 240 V AC, 50/60 Hz
Power Consumption
Power on 560 W 660 W
Stand-by condition Save off 1.2 W, Save on 0.7 W Save off 1.2 W, Save on 0.7 W
Power off condition 0.3 W 0.3 W
Plasma Display panel Drive method : AC type
58-inch, 16:9 aspect ratio
Drive method : AC type
65-inch, 16:9 aspect ratio
Screen size 1,284 mm (W) × 722 mm (H)
× 1,473 mm (diagonal)
1,434 mm (W) × 806 mm (H)
× 1,645 mm (diagonal)
(No.of pixels) 2,073,600 (1,920 (W) ×1,080 (H))
[5,760 × 1,080 dots]
Operating condition
Temperature 0 °C - 40 °C
Humidity 20 % - 80 %
Applicable signals
Colour System NTSC, PAL, PAL60, SECAM, Modifi ed NTSC
Scanning format 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 750 (720) / 60p · 50p, 1125 (1080) / 60i · 60p · 50i ·
50p · 24p · 25p · 30p · 24sF, 1250 (1080) / 50i
PC signals VGA, SVGA, XGA, SXGA
UXGA ···· (compressed)
Horizontal scanning frequency 15 - 110 kHz
Vertical scanning frequency 48 - 120 Hz
Connection terminals
LAN RJ45 10BASE-T/100BASE-TX, compatible with PJLink™
AV IN VIDEO
AUDIO L-R
BNC
RCA Pin jack × 2
1.0 Vp-p (75 Ω)
0.5 Vrms
HDMI TYPE A Connector
COMPONENT/RGB IN
Y/G
P
B/CB/B
P
R/CR/R
AUDIO L-R
BNC
BNC
BNC
RCA Pin jack × 2
with sync 1.0 Vp-p (75 Ω)
0.7 Vp-p (75 Ω)
0.7 Vp-p (75 Ω)
0.5 Vrms
DVI-D IN
AUDIO
DVI-D 24 Pin
Content Protection
Stereo mini jack (M3) × 1
Compliance with DVI Revision 1.0
Compatible with HDCP 1.1
0.5 Vrms
PC IN
AUDIO
High-Density Mini D-sub 15 Pin
VBS (use HD port)
Stereo mini jack (M3) × 1
Y or G with sync 1.0 Vp-p (75 Ω)
Y or G without sync 0.7 Vp-p (75 Ω)
P
B/CB/B: 0.7 Vp-p (75 Ω)
P
R/CR/R: 0.7 Vp-p (75 Ω)
HD/VD: 1.0 - 5.0 Vp-p (high impedance)
with picture 1.0 Vp-p (high impedance)
without picture 0.3 Vp-p (high impedance)
0.5 Vrms
SERIAL External Control Terminal
D-sub 9 Pin RS-232C compatible
EXT SP 6 Ω, 16 W [8 W + 8 W] (10 % THD) 8 Ω, 20 W [10 W + 10 W] (10 % THD)
Dimensions (W × H × D) 1,399 mm × 843 mm × 99 mm 1,554 mm × 925 mm × 99 mm
Mass (weight)
main unit only approx. 45.0 kg net approx. 55.0 kg net
with speakers approx. 50.0 kg approx. 60.0 kg
Notes:
• Design and specifi cations are subject to change without notice. Mass and dimensions shown are approximate.
• This equipment complies with the EMC standards listed below.
EN55022, EN55024, EN61000-3-2, EN61000-3-3.
20
To Next Page
Loading...
