External scaler mode
Power save
PC Power management
Auto power off Off
Off
Off
Off
OSD design Type1
OSD position Upper left
OSD Language English (UK)
Signal
Extended life settings
Screensaver
Network Setup
Input label
Component/RGB-in select
RGB
3D Settings
Express settings
Custom settings
Reset
Extended life settings
30
Off
Unlock
High
Dynamic
Mid
Contrast
Picture Mode
Extended life settings
Recommended settings
Side panel
NANODRIFT Saver
Peak limit
Lock settings
Apply to current input
Apply to all inputs
2
access
1
select
48
Setup menu
Extended life settings
Side panel
Do not display a picture in 4:3 mode for an extended period,
as this can cause an image retention to remain on the side
panels on either side of the display eld.
To reduce the risk of such an image retention, illuminate
the side panels.
This function may be applicable to the non-picture area.
Off: Darken both ends.
Low: Make it dark gray.
Mid: Make it gray.
High: Make it light gray.
Notes:
• To reduce the occurrence of image retention, set the Side panel to High.
• The side panel may ash (alternate black/white) depending on the picture being shown on the screen. Using Cinema
mode will reduce such ashing.
side panel
4:3 Screen
Display
image
retention
The following settings are setup to reduce image retention:
Image Retention Reduction Menu
“Extended life settings” enables you to set the following 5 menus (Image Retention Reduction Menu) as recommended
values or set them individually.
Picture Mode
Contrast
“Picture Mode” and “Contrast” are same as “Picture” menu items (see page 29). The settings of this menu will be
re ected to the “Picture” menu.
Set to the recommended value
Set individually
Reset to the factory settings
Image Retention Reduction
Menu
To Next Page
Loading...
