- 20 -
2. Select Timer Off Timer with / and press OK to access
3. Select the time in 15-minute increments with
/ and press OK to set
90 / 75 / 60 / 45 / 30 / 15 / Off (minutes)
●
To cancel, set to Off or turn the TV off.
●
The remaining time displays on the information banner.
Watching Basic Information banner
●
When the remaining time is less than 3 minutes, the remaining time will
flash on the screen.
Last view
Switch to a previously viewed channel or input mode easily with LAST VIEW.
●
Press again to return to the current view.
= Note =
●
Switching channel is not available while the recording of Timer
Programming or One Touch Recording is in progress.
●
Watching less than 10 seconds is not reflected in the previously viewed
channel or input mode.
Adjusting time
■ Adjust the standard time
Select the region where you live to adjust the standard time. (Base on GMT)
1. Display the menu with MENU
2. Select Timer
Clock Settings Region Select with / and press OK
to access
3. Select the region with
/ and press OK to set
NSW / ACT / Victoria / Queensland / South Australia / Western Australia /
Northern Territory / Tasmania
●
The time contained in the broadcast signal is UTC (Universal Time
coordinated) formally known as GMT (Greenwich Mean Time).
NSW / ACT / Victoria / Queensland / Tasmania: +10:00
South Australia / Northern Territory: +9:30
Western Australia: +8:00
■ Adjust for Summer Time
Select time offset from the standard time for Summer Time. (Base on GMT)
1. Display the menu with MENU
To Next Page
Loading...
