35
PC Card / ExpressCard
You can insert the following cards.
z ExpressCard/34 or ExpressCard/54 to the ExpressCard slot (A)
(Only for model with ExpressCard slot)
z PC Card Type I (3.3 mm) or II (5.0 mm) to the PC Card slot (B)
z For model with Smart Card slot (Î page 41)
NOTE
z The following types of card are not supported:
PC Card Type III (10.5 mm), ZV card, SRAM card, FLASH ROM card (excluding ATA interface type), and other cards
that require 12 V of operating voltage.
z Do not start up Windows with a storage type of CardBus PC card attached. An error may occur.
z Dummy cards are inserted into both of the slots at the factory.
First remove the dummy cards.(Î page 42 Step 1)
z Be sure to insert each dummy card when the slots are not in use.
z Insert the appropriate dummy card in the correct card slot. Insert the dummy PC Card in the PC Card slot, and the
dummy ExpressCard in the ExpressCard slot.
Inserting a dummy card in the wrong slot may cause malfunction of the computer.
To insert the card
1 Open the cover.
A Slide the latch (C) to the right to unlock the cover.
B Slide the latch (C) down, and open the cover.
Inserting/Removing the Card
To Next Page
Loading...
