82
Disabling/Enabling Wireless Communication
Checking the status of the wireless connection
NOTE
z The Wireless Switch Utility should also be installed so that the Wireless Connection Disable Utility works. The Wire-
less Switch Utility has already been installed at the factory.
z To use the utility, set [Wireless Switch] to [Enabled] in the [Advanced] menu of the Setup Utility (Î page 93).
Status indication
After installation, the Wireless Connection Disable Utility is automatically started after a user is logged in. An icon appears
when click on the notification area.
: Indicates that
• the utility is enabled, and
• the wireless connection is disabled since a LAN cable is connected.
: Indicates that
• the utility is enabled, and
• the wireless connection is enabled since no LAN cable is connected.
: Indicates one of the following statuses;
• the utility does not monitor the LAN port status,
• the Wireless Switch Utility has not been started, or
• [LAN] is disabled in the [Advanced] menu of the Setup Utility or in the device manager.
Menu
Right-clicking the utility icon opens a menu as follows.
Clicking the menu item causes the following utility action.
Monitoring LAN Cable: ON
Enables the Wireless Connection Disable Utility to monitor the LAN port and disable wireless
connection when a LAN cable is connected.
Monitoring LAN Cable: OFF
Disables the Wireless Connection Disable Utility, and enables wireless connection regardless of whether a LAN cable is con-
nected or not.
Exit
Exits the Wireless Connection Disable Utility and enables wireless connection.
To Next Page
Loading...
