95
Setup Utility
Boot Prompt Configuration Underlined items are the factory presets.
Security Menu
Setup Utility Prompt
• When [Setup Utility Prompt] is set to [Disabled], the message “Press F2 for Setup / F12 for LAN”
is not displayed on [Panasonic] boot screen. However, F2 and F12 will work even if the message
is not displayed.
Disabled
Enabled
Password On Boot Disabled
Enabled
Set Supervisor Password Enter the sub-menu.
Hard Disk Lock
• Can be changed only when [Set Supervisor Password] is set.
Disabled
Enabled
User Password Protection No Protection
Protected
Set User Password
• Can be changed only when [Set Supervisor Password] is set.
Enter the sub-menu.
XEmbedded Security(TPM)
• Only for model that supports TPM
• For information on TPM, refer to the Installation Manual of “Trusted Platform Module (TPM)”.
Click (Start), input “c:\util\drivers\tpm\readme.pdf” in [Search programs and files], and press
Enter
.
Enter the sub-menu.
XFingerprint Security
• Only for model with Fingerprint Reader
Enter the sub-menu.
XAMT Configuration Enter the sub-menu.
To Next Page
Loading...
